Cleaning And Maintenance - PROZIS Mini Quaik Manual Del Usuario

CLEANING AND MAINTENANCE

• Switch off the device and remove all plugs before cleaning!
• Wipe the surface of the device with a slightly damp towel, then dry it with a soft cloth.
Never wipe the bottom charging socket with a wet towel.
• Do not use aggressive or abrasive cleaning agents or materials such as scouring milk or
steel wool to clean the components. They can damage the upper surface of the device!
• Protect the device from water drops and water spray.
• Make sure moisture does not enter the device while cleaning to prevent damage to the
product and related repairs.
STORAGE
• Place the equipment inside the original box for storage, or when traveling for a long period
of time.
• Keep the device away from liquids or heat sources. Keep the vent free of dust and debris.
When no longer using the device, store it in a dry environment, protected from dust and
direct sunlight.
• Store in a dry, well-ventilated location, free from corrosive gases. It should be stored at no
less than 25 cm from the ground, and under no more than 5 stacked items.
• If the device is not going to be used for a long period of time, you should recharge it on a
regular basis. This helps maintain battery performance. Charge it every month.
• This device must be secured during transportation to prevent any violent vibration, col-
lision, tumbling, and falling, and it should be kept upright. Set it down gently, and avoid
placing it over wet or damp areas.
INSTRUCTIONS
Product description: see page 2, figure A
1.Matt aluminum alloy body 2.Massage head socket 3.Power indicator light 4.Intensity level
indicator lights 5.Power/intensity button 6.Type-C Interface
Massage heads: see page 2, figure B
1.Ball head 2.Fork head 3.Flat head 4.Jade head
OPERATING INSTRUCTIONS
Massage head assembly: see page 2, figure C
Hold the massager's body firmly with your left hand while holding the massage head with
your right hand. Push firmly until the massage head is locked.
Tip: Rotate the head gently during the press-and-pull process.
Switching the device on and off
• To switch on: Long-press the power/intensity button to switch on the device. It will enter
standby mode.
• Level 1: Short-press the power/intensity button once the device is in standby mode. It will
start on level 1.
EN
9 9