Craftmade Rugged Guia De Instalacion página 7

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket. Turn
the hanging ball slot until it lines up with the hanging
bracket tab. [Refer to diagram 5.]
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw, washer
and lock washer (not supplied) with the safety cable
loop. If necessary, adjust the loop at the end of the
safety cable. The loop at the end of the safety cable
should just fit over the threads on the wood screw.
Test safety cable by pulling on loose end with pliers. If
the safety cable slips, the loop must be adjusted tighter.
Extra cable slack can be left in ceiling area.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position.
CAUTION: Be sure outlet box is properly grounded and that a
ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes or
Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires are
different colors than those referred to in the diagram to the right,
please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging bracket,
WIRE THE RECEIVER with wire connectors provided as shown
in diagram at right.
Tip: While you are wiring, keep in mind that wires must not
obstruct receiver from sliding into hanging bracket.
* Wrap each wire connector separately with electrical tape as
an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket and
carefully push taped wire connectors into outlet box. Allow
antenna from remote control receiver to hang outside of
hanging bracket.
["Wiring" continued on next page.]
wood ceiling joist
diagram 5
white supply wire
black supply wire
blue
black
white
from fan
from receiver
Lorem ipsum
white
black
blue
(wiring for receiver)
page 7
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
motor housing
ground (green
or bare)
from ceiling
from receiver
black
AC IN L
white
AC IN N
antenna
receiver
ground (green
or bare)
*