Descargar Imprimir esta página

Infiniton FSB-618 Manual De Usuario página 31

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Disconnect the power supply before defrost the appliance.
3. Open the door and take out the beverages. Knock the frost gently. Wait until
the defrost water is drained. Please clean with soft cloth dipping with warm
water or neutral soap liquid. Be sure to wipe with pure water after using
neutral soap liquid.
4. Never attempt to scrape/remove ice/frost with sharp objects (such as knives,
shovels, etc.). Use a plastic scraper.
5. After defrosting, reconnect the appliance to the power supply.
Cleaning inside the appliance
Before maintenance, switch off the appliance and disconnect the mains plug from
the mains socket. After defrosting you should clean the appliance internally with a
weak solution of bicarbonate of soda. Then rinse with warm water using a damp
sponge or cloth and wipe dry. Wash the baskets in warm soapy water and ensure
they are completely dry before placing them back. Condensation will form on the
back wall of the refrigerated showcase; however, it will normally run down the
back wall and into the drain hole.
Cleaning outside the appliance
Before maintenance, switch off the appliance and disconnect the mains plug from
the mains socket. Use standard non-abrasive detergent diluted in warm water to
clean the outside.
The grille of the condenser at the back of the appliance and the adjacent
components can be vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents to clean any part of the
appliance.
Moving the unit
When moving the appliance, make sure not to tilt it more than 45°.
▪ Location
Do not place your equipment near a heat source, for example. Stove, boiler or
radiator. Also, avoid direct sunlight.
▪ Do not turn on the appliance for 4 hours
After any movement, it must not be connected for 4 hours. This time allows the
coolant to adjust.
▪ Installation
Let your device breathe. Heat is released from the walls so it is important to leave
enough space around the appliance so the air can circulate.
13

Publicidad

loading