CORRECT USAGE
CAUTION: DO NOT PUSH SHAFT LOCKING BUTTON (6) DURING USE! PUSH THE BUTTON ONLY
WHEN THE SWITCH (2) IS IN OFF POSITION.
• This tool is designed to be used as a polisher, sander, cleaner, brusher.
• This tool is not intended to be used for metal brushing and cutting-off operations. The use of this tool for
unintended applications may cause hazards and injuries to people.
• Air vents often cover moving parts and should be avoided. Loose clothes, jewellery or long hair can be
caught in moving parts.
• Clean out your tool often, especially after heavy use. Dust and grit containing metal particles often
accumulate on interior surfaces and could create an electric shock hazard.
• The tool must be used with accessories that have been specifically designed or recommended by the
manufacturer. The fixing of the accessory to the tool does not guarantee a safe operation.
• The rated speed of the accessories must be at least equivalent to the maximum speed specified on the
tool. Using the accessories at speeds above the rated one, may cause them to break or be projected into the air.
• The external diameter and thickness of the accessories must match the specifications of the tool.
Accessories with incorrect dimensions cannot be adequately protected or controlled.
• The configuration of accessories must match the tool. The use of accessories that cannot be perfectly fitted
on the tool may result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
• Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads
and verify there are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it
is not damaged or install a new accessory. After inspecting or installing an accessory, test the operation
of the tool at maximum speed and without load for one minute, keeping at a safety distance. If the
accessories are damaged, they will break during this test.
PARTS OF THE TOOL
1 - Identification plate
2 - ON/OFF / speed regulation Knob
3 - Buffer pad (not supplied)
4 - Velcro faced disc pad
5 - Motor ventilation slots
6 - Shaft locking button
7 - ON/OFF switch lever
MOTOR
WARNING: To reduce the risk of injury, only the Li-ION Battery Pack 9HB120LT/9HB125LT or the
Power supply 9HP120LT (optional) for the motor supply should be used with this product.
The tool is operated by a DC motor. Since the batteries, other than those offered by Rupes, have not been tested
with this product, use of such batteries with this tool could cause the injury and property damage.
SWITCH
WARNING: To reduce the risk of injury, turn the knob (2) until OFF position after any use.
To turn the unit on, rotate the potentiometer knob (2) and set up the speed from 1 to 5 value. Push the switch lever
(7) towards the body of the tool.
To turn it off, release the lever and rotate the potentiometer knob until OFF position.
ELECTRONIC CONTROLLER
The main functions of electronic controller are: Speed control, Batteries and motor protection, Battery pack
lever indication, Soft start.
Speed control
The speed of your tool can be changed by rotating the speed regulation knob (2) to the desired setting.
The speed regulation knob (2) can be set for any speed between 2000 and 5000 RPM.
8 - Battery pack 10,8V cod 9HB120LT/9HB125LT
9 - Battery level LED
10 - Power supply 9HP120LT (optional)
11 - Functional unit shaft: Red color orbit 12,
Blue color orbit 3,
Green color rotary version
12 - Extention shaft 291.390
7