Rupes HR81M Manual De Instruccion página 9

BATTERY PACK (PROVIDED OR OPTIONAL)
WARNING: Avoid short circuiting the contacts. Avoid mechanical damage of the battery pack. Do not
open or disassemble. Advice on protection against fire and explosion. Keep away from open flames,
hot surfaces and sources of ignition.
Temperature in excess of 45°C reduce the performance of the battery pack. Avoid extended exposure to heat
or sunshine. Storage at room temperature (approx. 20°C) at approx. 20~60% of the nominal capacity. Every six
months of storage, charge the battery pack as normal.
Intended use
The battery pack 9HB120LT/9HB125LT (Fig. 9) is used as the power source for Rupes BIGFOOT NANO iBrid tool
HR81M/HR81ML.
Battery pack 9HB120LT/9HB125LT specifications
WARNING: for technical data refer to the label of Battery pack 9HB120LT/9HB125LT
WARNING: to reduce the risk of injury or explosion, never burn or incinerate a tool's battery pack even
if it is damaged, dead or completely discharged. When burned, toxic fumes and materials are created.
Model Chemistry
9HB125LT Lithium Ion
9HB120LT Lithium Ion
WARNING: charge Rupes Li-ION Battery pack 9HB120LT/9HB125LT only in the Rupes Li-ION Battery
Charger 9HC120LT. Other types of batteries may cause personal injury and damage.
This tool's battery pack and charger are not compatible with NiCd or NiMH systems.
When to charge
Charge your battery tool when convenient for you and your job. The Rupes BIGFOOT NANO iBrid tool Battery
pack does not develop "memory" when charged after only a partial discharge. It is not necessary to run down the
battery tool pack before placing it on the charger. Use the led Battery pack 9HB120LT/9HB125LT lever indication
on the Rupes BIGFOOT NANO iBrid tool HR81M/HR81ML to determine when to charge the Rupes Battery pack.
Charge the battery pack 9HB120LT/9HB125LT (8)
The battery pack(s) contained in the kit shall be charger before use. The provided battery is charged <30%. In order
to charge connect the Li-ion battery with a charging station 9HC120LT till the charging is completed.
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of
charging station 9HC120LT before using.
Assemble battery pack 9HB120LT/9HB125LT
WARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF
position.
In order to assemble the battery pack push two clips (Fig. 9) at the same time and insert the battery pack in the
tool till it is fixed.
In order to disassemble push two clips at the same time and extract the battery from a tool (Fig.10).
POWER SUPPLY (PROVIDED OR OPTIONAL)
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of
Power supply 9HP120LT before using.
Voltage (V) Capacity (Ah)
10.8 2.5
10.8 2.0
Energy (Wh) Weight (kg)
27÷27.75 0.183 ±0.005
21.6 0.183 ±0.005
9