Publicidad
Idiomas disponibles
Idiomas disponibles
EN
• Transport the compressor by lifting it or by
using the special grips or handles.
• Children and animals should be kept far away
from the area of operation of the machine.
• If you use the compressor to spray paint:
a) Do not work in enclosed spaces or near
naked flames.
b) Make sure that the environment in which you
will be working has dedicated ventilation.
c) Protect your nose and mouth with a dedicated
mask.
• Do not use the compressor when the electrical
cable or the plug is damaged, and instruct an
authorised Support Service to replace them
with an original part.
• When the compressor is placed on a surface
higher than the floor, it should be secured to
prevent it from falling down during operation.
• Do not put objects or your hands in the pro-
tective covers to avoid physical damage and
damage to the compressor.
• Do not use the compressor as a blunt instru-
ment against persons, objects or animals in
order to prevent serious damage.
• If the compressor is no longer in use, always
take the plug out of the plug socket.
• Always make sure that compressed-air hoses
are used for compressed air and which are
characterised by a maximum pressure adjusted
to that of the compressor. Do not try to repair
the hose if it is damaged.
SAFETY INSTRUCTIONS FOR WORKING WITH
COMPRESSED AIR GUNS
• The compressor and hoses can get very hot du-
ring operation. Touching them can cause burns.
• The gases or vapours sucked in by the com-
pressor intake must be kept free of admixtures
that could lead to fires or explosions inside the
compressor.
• When removing the hose coupling, always hold
the hose coupling firmly to avoid injury caused
by the hose flying off.
• When working with the blow-out gun, wear
goggles. Foreign bodies and blown out particles
can easily cause injuries.
• Do not direct the blow-out gun at people or use
it to clean clothing you are wearing.
6
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating plate.
Connecting to the power supply
Check that the power supply and plug used in
accordance with your machine. Have a look at the
rating plate on the machine. Any changes should
always be carried out by a qualified electrician.
Warning! This machine must be earthed. If
not properly earthed this machine can cause
an electrical shock. Be sure that the power
supply outlet is earthed. If there is any doubt,
have it checked by a qualified electrician.
Warning! Avoid contact with the terminals
on the plug when installing (removing) the
plug to (from) the power supply outlet.
Contact will cause a severe electrical shock.
Replacing cables or plugs
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard. Immedi-
ately throw away old cables or plugs when they
have been replaced by new ones. It is dangerous to
insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
always unwind the reel completely.
2. MACHINE INFORMATION
Intended use
The compressor is designed to generate compressed
air for compressed air driven tools. This compressor
is not designed for continuous operation.
. When using a cable reel
WWW.VONROC.COM
Publicidad
