Publicidad
Idiomas disponibles
Idiomas disponibles
2. If any water is left in the Water Reservoir, pour
the water out and wipe the Water Reservoir and
Base with a dry, clean cloth or paper towel. Never
immerse the Base in water or other liquid.
3. Replace the Vent Assembly and Inhaler Mask.
Store in a cool, dry place.
Routine Maintenance
Perform the following cleaning procedures if using
the Steam Inhaler ten or more times a week, when
scale builds up in the Water Reservoir, or if not used
for long periods.
1. Remove Inhaler Mask and Vent Assembly.
2. Pour two ounces of undiluted white vinegar into
the Water Reservoir and let sit for 10 minutes.
3. Empty the white vinegar and clean the Water
Reservoir with fresh, clean tap water.
4. Dry the Water Reservoir and Base with a clean
cloth or paper towel.
5. Wash Inhaler Mask with mild soap and warm
water then carefully rinse off all soap with fresh,
clean tap water.
6. Dry the Inhaler Mask with a clean cloth or paper
towel.
7. Replace Vent Assembly and Inhaler Mask. Store
them in a cool, dry place.
Disposal
Observe the local regulations for material disposal.
Dispose of the device in accordance with local
regulations. If you have any questions, please contact
the local authorities responsible for waste disposal.
6� Technical Specifications
Model:
Dimensions
(L x W x H)
Power supply:
SI 30
6 x 7.6 x 9.7 inches
(153.5 x 193 x 247.5 mm)
120 V / 60 Hz
Current
consumption:
Power
consumption:
Weight:
Filling volume
of internal water
heater:
Operating
Conditions:
Storage and
transportation
conditions:
7� Warranty
Your Beurer Steam Inhaler, model SI 30, is warranted
to be free from defects in materials and workmanship
for the life of the product under normal conditions of
intended use and service. This warranty extends only
to the original retail purchaser and does not extend
to retailers or subsequent owners.
We will, at our option, repair or replace the Beurer
Steam Inhaler, model SI 30, without additional
charge, for any part or parts covered by these
written warranties. No refunds will be given. Repair or
replacement is our only responsibility and your only
remedy under this written warranty. If replacement
parts for defective materials are not available, Beurer
reserves the right to make product substitutions in
lieu of repair or replacement.
For warranty service contact our customer service
department at 1-800-536-0366 or at info@beurer.
com to provide a description of the problem. If the
problem is deemed to be within the scope of the
limited lifetime warranty, you will be asked to mail
the product at your costs in its original package with
6
510-650 mA (steady use),
670-830 mA (first minute)
70 W (steady use),
90 W (first minute)
approx. 19.2 oz (544 g)
(with mask and water cup)
1.35 fl oz (40 ml)
50°F~104°F (10°C~40°C),
30~85% RH
14°F~122°F (-10°C~50°C),
30~85% RH
Publicidad
