JL Audio XDM 1000/1 Manual Del Propietário página 4

CONNECTIONS
1
Connection
+12 VDC Positive (+12V) Power Connection
1
Ground Negative (GND) Ground Connection
Remote Positive (+12V) Activation Connection
CH. 1 Input Left Input Signal, Black RCA
CH. 2 Input Right Input Signal, Red RCA
2
Preout 1 Left Pass-Through Preamp Signal, Black RCA
Preout 2 Right Pass-Through Preamp Signal, Red RCA
Remote Level Remote Level Controller Connection (optional)
3
Control (HD-RLC or MHD-RLC)
Mono
4
Subwoofer
Output
4 | JL Audio® - XDM1000/1
2
Description
(+) Positive Subwoofer Output
(+) Positive Subwoofer Output
(–) Negative Subwoofer Output
(–) Negative Subwoofer Output
3 4
Notes
• 4 AWG wire (required)
• Install 80A fuse at (+) battery post
• 4 AWG wire (required)
• 18 – 12 AWG wire capacity
• See Turn On Mode for more info
• Accepts 200mV – 4V input voltage
• If only one subwoofer channel signal is
available, a Y-adaptor is recommended
to feed both inputs.
• Same signal that is connected to
CH. 1&2 inputs
• Unaffected by the amplifier's LP filter
• Operates as an attenuator only:
Fully counter-clockwise = Level Muted
Fully clockwise = Level Unaffected
• Multiple amplifiers can be controlled
from a single HD-RLC using a non-
duplex phone line splitter and multiple
phone cables.
• Both positive (+) connections are
connected in parallel internally
• Both negative (–) connections are
connected in parallel internally
• Minimum impedance load: ≥2 ohms
• 16 – 8 AWG wire capacity