Publicidad
Idiomas disponibles
Idiomas disponibles
● To change heating mode, press the
ECO mode
, Comfort mode
flash as you cycle through them. After a few seconds the mode icon will stop flashing
and the heater will heat in that mode.
● To adjust the set temperature of any of the modes, you can then use the UP
and DOWN
5°C –50°C.
● To set the timer, press the
Timer range is 1 – 24 hours. The digits will flash while setting and then the screen will
return to heating mode. The timer icon
been set. The heater will heat until the time has elapsed.
● To schedule your heater to switch on later, press the
standby mode. U. Delay range is 1 – 24hours. The digits will flash while setting and
then the screen will return to heating mode. The timer icon
show that the timer has been set. The heater will switch on when the delay has
elapsed.
● To set the child lock, press and hold the
appear on the screen and the control panel will be locked out. To release, press and
hold the down
buttons can be used again.
● Long Press the time button can turn off all the display lights and press any key to
light up the display screen of the product. When the operation is stopped over 30
seconds, the product will enter low light mode.
Change the battery: Please follow below instruction to remove the old cell button. Then
insert a new CR2025 cell button. If the heater will not be used for a long time, please take
out the battery in the remote control.
Technical Data
Type
820-338V90BK
and anti-frost mode
buttons to adjust the temperature. Temperature range is from
TIME button while the heater is in heating mode.
button. The padlock icon will disappear, indicating that all the
Voltage
Frequency
230V
MODE button to cycle through the modes:
on the screen will show that the timer has
UP button. The padlock icon
Power
50/60Hz
2000W
33
. The mode icons will
TIME button while on
on the screen will
will
Category
Publicidad
