Connecting Power - Guardian 415-3T Manual Del Propietário

Connecting Power

To prevent possible FROM ELECTROCUTION or FIRE:
- Power MUST be DISCONNECTED BEFORE proceeding with permanent wiring procedures.
- Garage Door Opener installation and wiring MUST be in compliance with all local electrical and
building codes. Make sure the Opener is ALWAYS grounded.
- NEVER use an extension cord, 2-wire adapter or modify the power plug in any way to make it fit the
outlet.
To prevent SERIOUS INJURY or DEATH from a closing garage door:
- The Photo Eye Safety System MUST be installed BEFORE connecting power.
- The Photo Eye Safety System MUST be properly connected and aligned BEFORE operating the
Opener.
Ordinary Power Connection
For Permanent Wiring ONLY
Conduit with wire
Line (Black)
Neutral (White)
White (From Light)
White
(From Logic Board)
(From Logic Board)
Yellow
(From Motor)
To Align Photo Eye Safety System
1. When the photo eye safety system is properly aligned green LED (emitter) will emit a steady green light and the red LED
(sensor) will emit a steady red light. The path of the invisible light beam MUST NOT be obstructed. No part of the garage
door or any hardware should interfere or block either sensor.
2. Green LED (emitter) will flash until it is aligned with red LED (sensor). Red LED will not illuminate until it is aligned with
green LED. The emitter generates the invisible light beam, and the sensor receives the invisible light beam.
WARNING
Ground (Green/Yellow)
Ground Screw (Green)
Wire nut
Black
Invisible Light
Beam
DO NOT OPERATE OPENER AT THIS TIME.
To Connect Power
Plug the Opener into a grounded outlet ONLY. If there is no
grounded outlet present, call a qualified electrician to replace the
outlet.
Permanent Wiring (If Required by Local Code)
1. Remove the enclosure by removing the 6 screws located
on the sides and rear of the Opener.
2. Cut the two cable pressure connectors connecting line
(black) and neutral (white) wire from the power cord.
3. Remove the grounding screw connecting the green wire.
4. Remove the power cord.
5. Group neutral (white) wires from power source with 2 white
wires from light cable, and logic board, and yellow wire
from motor, inside the Opener. Connect them with a wire
nut.
6. Group line (black) wires from power source with another
black wires from logic board inside the Opener. Connect
them with a wire nut.
Emitter
Green LED ON
Sensor
Red LED ON
Aligned
Steady Red &
Green LED
www.adhguardianusa.com 16