Assembling Sectional Rail - Guardian 415-3T Manual Del Propietário

Assembling Sectional Rail

To prevent SERIOUS INJURY:
- DO NOT connect power until instructed.
- To prevent INJURY, keep hands and fingers away from joints and possible sharp edges.
- Keep hands and fingers clear from sprocket during operation.
- Wear gloves when installing chain and cable.
- Keep hands and fingers away from joints and possible sharp edges
To Mount the Rail
1. Attach the Header, Middle, and End rail segments together with the two braces, using the 5/16" carriage bolts and
flange nuts provided.
2. Slide the trolley assembly along the rail to the header segment.
3. Install the front idler sprocket with the two 1/4" bolts and nuts provided.
4. Align the holes on the end segment of the T-rail with the holes in the motor unit and fasten the rail with (2)
bolts.
Rail – Header Segment
Rail - Middle Segment
Riel – End Segment with stop bolt
2 Brace rail joints
Rail – Header Segment
Flange Nut 1/4" -20 (2)
Trolley
Front Idler
Sprocket (1)
WARNING
5/16" Flange Nut (8)
Riel – End segment with stop bolt
Brace (2)
Rail - Middle Segment
Carriage Bolt (8)
5/16" - 18 x 1/2"
Bolt 5/16" - 18 x
1/2" (2)
www.adhguardianusa.com 6