Searing Burner - Kenmore PG-40409S0LB-COSG Manual De Uso Y Cuidado

Searing Burner

7
 Remove plastic packaging from searing burner valve. Remove searing burner grate from searing burner shelf.
 Remove the 2 pre-installed screws from the valve control stem and set them aside. (A & B)
 Loosen the searing burner to insert gas valve. First loosen and remove the screw attaching the electrode etc. (C)
to the shelf and set it aside. Then loosen and remove the 2 screws holding searing burner in place. (D)
 Insert the gas valve into the searing burner (E). Insert valve control stem through hole in fascia (F). Install the 2
previously removed valve control stem screws, but do not fully tighten until attaching bezel to fascia.
 Reattach searing burner to shelf with the 2 previously removed screws. (G) Reattach electrode to shelf with
previously removed screw from searing burner. (H)
 Insert bezel openings over valve control stem and the 2 screws. (I) Slide bezel down onto screws. Make sure
that black mark on bezel is vertical. Tighten the 2 screws to secure bezel to fascia. (J)
 Push control knob onto searing burner valve stem. (K)
 Replace searing burner grid. (L)
 Connect both igniter wires to the igniter module on the underside of the searing burner shelf fascia. To connect,
push igniter wire tips onto pins in igniter module. (M)
 Slide searing burner drip box into the drip box bracket. (N)
 Unscrew igniter cap from control panel. Insert (1) AA battery (provided in blister pack) into battery slot with
positive end (+) facing outward. Screw igniter cap back onto panel. (O)
25