Descargar Imprimir esta página

Parts And Components; Before Installation - cecotec BOLERO AGUAZERO 6400 Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Top cover
2. Cutlery tray
3. Height-adjustable cup holder
4. Upper basket
5. Upper spray arm
6. Portable cutlery basket
7. Lower spray arm
8. Lower basket
9. Rinse aid compartment
10. Door
11. Detergent tank
12. Turbo dryer: this system improves the tableware drying performance.
Note
The graphics in this manual are schematic representations and may not exactly match the
product.

2. BEFORE INSTALLATION

-
This product includes a safety package to protect it during transport. Unpack the appliance
and keep the original packaging and materials in a safe place. It will help prevent any
damage if the product needs to be transported in the future. In case the original packaging
is disposed of, make sure all packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.
Box contents
Bolero Aguazero 6400/Inox/Dark dishwasher
-
Drain hose
-
Water supply hose
-
Test strips
-
Instruction manual
-
62
3. INSTALLATION
Step 1: Selecting the dishwasher location
Fig. 2
When placing the machine, do it in an area in which the tableware can be loaded and
-
unloaded easily. Do not place the dishwasher in an area in which room temperature is
below 0°C.
Place the dishwasher near a tap, a water drain and a grounded electrical outlet. Remember
-
you should not modify the connections once the dishwasher is installed.
You must leave at least a 5-mm space between the upper part of the dishwasher and the
-
cabinet, and the exterior door must be aligned with the piece of furniture.
Follow the indications on image 2 on the dimensions the gap where you want to
-
install the dishwasher must have.
Do not hold the device by its door or panel.
-
Leave an appropriate distance around the machine to make its disconnection from the
-
mains and movement easier when cleaning it.
Step 2: Water supply hose connection
Fig. 3
Connect the water supply hose to a cold water tap, and make sure it is securely in place.
WARNING: use the water supply hose provided with your dishwasher, do not reuse the
water supply hose from your old dishwasher.
WARNING: open the tap and let water run through the water supply hose before
connecting it to the dishwasher.
WARNING: connect the water supply hose directly to the water inlet. The pressure
supplied by the inlet must be at least 0.03 MPa and at most 1 MPa. If the pressure is
over 1 MPa, you must install a pressure release valve in the connection.
When the connections are ready, open the tap completely and check if there is any
water leakage. Close the water supply tap after every washing programme.
Step 3: Draining hose connection
Fig. 4
Connect the drain hose directly to a drain or to the sink outlet tap. This connection must
-
be at least 50 cm and at most 110 cm over the floor level. Fig. 4
If the end of the drain hose is free, it should not be immersed in water, to prevent water
-
backflow.
Make sure the drain hose is not twisted.
-
ENGLISH
63
AGUAZERO 6400 / 6400 INOX / 6400 DARK

Publicidad

loading

Este manual también es adecuado para:

Bolero aguazero 6400 inoxBolero aguazero 6400 dark