Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – Metalux CBRK Emergency Transfer Relay with dimming control
Installation
1.
Mounting: The ETS-DR can be mounted inside a fixture
channel, on the back of a fixture, or near the fixture.
The flex conduit should be connected to a junction
enclosure that allows access to the wiring connections
for grounding.
Figure 1 - Emergency Battery component list
Components: ETS-DR (A), ETS-DR mtg screw (B), driver
bracket (C), driver bracket mtg screw (D) & ETS-DR MTG
Bracket (E) – Numbers in Bracket indicate Quantity
Mounting to back of fixture
i.
(a) Secure ETS-DR (A) to back side of LED Panel (X),
refer whichever Fig.2 best matches with available
CBRK fixture in the field.
(b) Use Driver Bracket (C) provided in ETS-DR KIT,
if the existing fixture is available with bigger driver
(40W).
(c) If the existing fixture in the field is with smaller
driver 20W/30W, then scrap driver bracket (C).
(X)
Figure 2- ETS-DR Assembly using brackets
OR
ETS-DR Assy 20W Driver non-sensor
ETS-DR Assy 30W Driver non-sensor
ETS-DR Assy 40W Driver non-sensor
COOPER LIGHTING SOLUTIONS
IB51921022
OR
OR
OR
Installation instructions
3
Publicidad
