Preparation For Operation - GRAPHITE 58G030 Traducción Del Manual Original

Explanation of used symbols
1 2
5 6
9 10 11
13 14 15
17 18
1.
CAUTION! Use precaution measures.
2,3. Read instruction manual, observe warnings and safety
conditions therein!
4. Use personal protection equipment (protective goggles,
earmuff protectors).
5.
Remove the battery from the device before starting any
adjustments or cleaning related tasks.
6. Use protective gloves.
7. Keep the tool away from children.
8. Use protective clothes.
9. The garden tool is designed for outdoors use
10. Do not put your hands or legs close to cutting parts!
11. Keep safe distance from working garden tool
12. Protect the tool from moisture.
13. When the device is operating do not put hands into its openings
14. Disconnect the charger before repairs.
15. Protection class 2.
16. The charger is designed to operate indoors in dry environment.
17. Do not throw cells into fire.
18. Maximum permissible cell temperature.
19. Recycling.
20. Do not allow other persons in the grass trimmer operation
range.
CONSTRUCTION AND USE
Cordless grass trimmer is a battery-powered tool. The drive consists
of DC commutator motor with permanent magnets. Tool of this type
is designed for tasks in home garden. The grass trimmer is designed
for trimming grass in corners and edges of lawns and flowerbeds,
wherever lawn mower cannot reach.
Use the power tool in accordance with the manufacturer's
instructions only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the
drawing pages of this manual.
1.
Edge rod
2.
Locking ring for telescopic pipe
3 4
7 8
12
16
19 20
3. Locking knob for auxiliary handle
4.
Auxiliary handle
5.
Switch
6.
Switch lock button
7.
Main handle
8. Spare cutting parts
9. Telescopic pipe
10. Locking button for head tilt angle
11. Guard
12. Cutting part
13. Head
14. Battery lock button
15. Battery
16. Charger
17. LED diodes
18. Button for battery level indication
19. Battery level indicator (LED)
20. Guard attachment screws
21. Spindle
22. Pin
* Differences may appear between the product and drawing.
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY / SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Guard
2.
Head with cutting parts
3.
Cutting parts
4.
Screws
5.
Screw

PREPARATION FOR OPERATION

REMOVING AND INSERTING THE BATTERY
• Push the battery lock button (14) and slide out the battery (15)
(fig. A).
• Insert charged battery (15) into the handle holder, you should
hear when the battery lock button (14) snaps.
BATTERY CHARGING
The battery for the device is supplied partially charged. Charge
the battery in ambient temperature between 4°C and 40°C. New
battery, or one that has not been used for a long time, will reach full
efficiency after approximately 3 to 5 charge/discharge cycles.
• Remove the battery (15) from the device (fig. A).
• Connect the charger to mains socket (230 V AC).
• Slide the battery (15) into the charger (16) (fig. B). Make sure the
battery is properly fitted (pushed to the end).
When the charger is connected to a mains socket (230 V AC), the
green diode (17) on the charger turns on to indicate connected
supply.
13
- 1 pce
- 1 pce
- 20 pcs
- 2 pcs
- 1 pce