Hansgrohe Talis S 32070000 Instrucciones De Montaje página 21

Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1 Flush through the supply pipes.
2 Place the mixer including the sealing
washer in position on the sink.
3 Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4 Connect the supply pipes to the isolation
valves; cold right - hot left.
5 Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
Rate of flow without EcoSmart:
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
English
7 l/min 0,3 MPa
14 l/min 0,3 MPa
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
If the continuous water heater causes any
problems or there is not enough flow of water,
the EcoSmart® (5a) located behind the aerator
must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 7.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 3
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 seal
6 aerator cpl.
7 fixing set
8 connection hose 450 mm
9 connection hose 450 mm
10 pull rod
11 locking screw for handle
12 spout cpl.
13 sealing set
Special accessories
X special tool set 58085000
(order as an extra)
32095000
96338000
96763000
97209000
92730000
95008000
94070000
13961000
94071000
97372000
96657000
96059000
96521000
92646000
5