Publicidad
Idiomas disponibles
Idiomas disponibles
The center of the groove must be run from the workpiece outer edge at least 50 mm.
With several wood joints 100 mm - 150 mm groove spacing hold.
Only for corner joint and center wall connection
The vertical workpiece clamp to the workbench.
Only with mitred
Clamp a workpiece with the mitered edge up on the workbench.
Only for frame connections and the longitudinal and transverse links
A workpiece clamp to the workbench.
Set the groove depth according to the size of the timber connector to be used.
See the table in the section "Setting the groove depth 12.1.3".
Adjust the angle stop on the cutting tool and workpiece center.
Align the center mark on the base plate on the pencil line on the workpiece.
Turn on the power and move it forward immerse the cutting tool into the workpiece.
After reaching the preset cutting depth the unit carefully drive back to the starting
position.
Only for corner joint and center wall connection
Clamp the horizontal workpiece at the workbench
The biscuit jointer machine is suitable for joints in solid wood, plywood, particle board, fiberboard,
Plexiglas and artificial marble, etc. 8 mm (5/16 in.) thickness.
11.4.2 Switching on / off
Never use the spindle lock during starting or when the machine is working.
Always make sure that the slide switch is working properly before connecting the machine
and when you press the rear panel to the "OFF" position returns.
The switch can be locked to make work easier for extended use in the "ON" position.
Be careful, when you lock the switch in the "ON" position, and hold the tool firmly.
To switch the unit to switch to the position "I" (ON) push. For continuous operation, the
switch into place by pressing its front.
To turn off the machine, press the rear of the slide switch and then the switch to the "O
(OFF)" push.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
OPERATION
20
PJ 100A
Publicidad
