Troubleshooting - cecotec BOLERO AGUAZERO 6800 STAINLESS STEEL Manual De Instrucciones

ENGLISH

9. TROUBLESHOOTING

Problem Possible causes
The dishwasher The fuse has blown or the
does not turn on circuit breaker has tripped.
The power supply is not on.
Water pressure is too low.
The dishwasher door is not
properly closed.
The water in the The drain hose is
dishwasher twisted or trapped.
is not drained
Blocked filter.
Blocked kitchen sink.
86
Solutions
Replace the fuse or restart the
circuit breaker.
Remove any other device sharing
the same circuit as the dishwasher.
Make sure the dishwasher is on and
door is properly closed.
Make sure that the power cord is
plugged into the socket properly.
Check the water supply is properly
connected and the tap is open.
Make sure you properly close the
door and it clicks.
Check the drain hose.
Check the filtering system.
Check the kitchen sink to make
sure it is draining correctly. If the
problem is the kitchen sink is not
draining, you may need a plumber
instead of the Technical Service.
Foam in the Unsuitable detergent.
interior
Spilled rinse aid.
The interior is You may have used
stained detergent with colouring.
White film on the Hard water.
interior surface
ENGLISH
Use only detergent special for
dishwashers to prevent foam
formation. If there is foam forming,
open the dishwasher and let it
evaporate. Add a litre of cold water
in the bottom of the dishwasher.
Close the dishwasher door and
select any cycle. At the start, the
dishwasher will drain the water.
Open the door after the drainage to
check the foam has disappeared.
Repeat this process if necessary.
Always clean spilled rinse aid
immediately.
Make sure your detergent does not
contain colouring.
To clean the interior, use a soft
and damp cloth with detergent for
dishwasher and use rubber gloves.
Never use any cleaner other than
dishwasher detergent, as this may
cause foaming.
87
AGUAZERO 6800 STAINLESS STEEL