Descargar Imprimir esta página

Regulatory Information - GoPro Volta Guia Del Usuario

Publicidad

Idiomas disponibles

Idiomas disponibles

Using Volta with Media Mod
Insert your GoPro into Media Mod (sold separately) as you normally would and
follow these steps:
1. Use your camera's mounting fingers to attach your GoPro to Volta.
Heads Up: Insert your camera into the mounting fingers with the Media Mod's
USB port on the same side as the camera cable and Thumb Screw. Rotate the
mounting fingers if needed to ensure that your camera is mounted properly.
2. Plug Volta's USB-C cable into the USB-C port on the back of your Media Mod.
3. Connect Volta to your camera via Bluetooth to use Volta's built-in camera
controls.
WARNING: Volta is not weather resistant when used with
Media Mod.
Resetting Volta
Press and hold the Mode + Power button
simultaneously for 8 seconds if you need to reset Volta.
Heads Up: You will not have to re-pair your camera if you reset Volta.
Notes
Here are a few important things to keep in mind while you're using Volta:
• Volta will enter power save mode if it is not used for 24 hours. Press any
button to wake it up.
• Disconnect Volta's Bluetooth connection to your camera if you want to
connect your camera to the GoPro Quik app. Press Bluetooth button
to disconnect.
• Volta can only pair and connect to one camera at a time.
• Volta's operating ambient temperature range is 14° F – 95° F (-10° C – 35° C).
It's normal charging temperature range is 32° F – 95° F (0° C – 35°C). Volta will
automatically shut down if it's too hot or too cold. The LEDs will blink red 4x
to show that it needs to return to its normal operating temperature before
the camera control buttons and camera charging will work. You can check its
status by pressing any button. The LEDs will blink red if it's not ready.
WARNING: Volta is not waterproof. Using it under water will
damage both Volta and your camera.

Regulatory Information

To see additional information regarding country certifications, refer to the
Important Product + Safety Instructions included with your remote.
The Bluetooth word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc., and any use of such marks is under license.
and Shutter button

Publicidad

loading