Factory Reset - Snom C300 Guia De Inicio Rapido

Note: If the C300 is playing media from a Bluetooth device, it will switch to playing
media from the PC once the PC is connected via USB cable.
Using the C300 to charge an external device
1. Plug the USB cable into the USB type-A port of the C300.
2. Plug the other end of the USB cable into the USB type-C port of the external device.
Note:
• The C300 must be on and the battery must not be low.
• You can charge the batteries of the C300 and a connected external device at the same time
(second USB cable not included in delivery).
Checking the battery level of the C300
Press briefly. The circle LEDs turn purple one by one to indicate the battery charge level. The
more purple LEDs displayed, the higher the battery charge level.
Low battery warning
The eight circle LEDs flash red twice, and, when not in a call, the device beeps rapidly four times.
The warning is repeated every three minutes.
App
The Snom Connect app is available in the iTunes store and the Google Play store. This app enables
you to perform the following functions on the C300 speakerphone:
• Change speakerphone settings
• Update firmware
For more information, refer to the app's online help — tap

Factory reset

1. In idle mode, press
and the C300 plays a tone.
2. Press twice within three seconds. The LEDs turn off, and the C300 plays three ascending
tones.
for 5 seconds. Circle LEDs 1, 3, 5, 7 flash red quickly for three seconds,
ENGLISH - important information
and then Help.
11