Restoring Factory Settings - HomeMatic HmIP-eTRV-CL Instrucciones De Montaje

Fast orange
flashing
Brief steady or-
ange light (after
green or red
confirmation)
6x long red
flashes
1x orange and 1x
green light (after
inserting batter-
ies)
Alternating long
and short orange
flashing
10

Restoring factory settings

The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
Open the battery compartments by pulling the cover (F) first
•
downwards and then forwards (see figure 3).
• Remove one battery.
Direct pairing mode
active
Batteries empty
Device defective
Test display
Device software up-
dating (OTAU)
Restoring factory settings
Activate the pairing mode of
the device you want to add
(see see „5.1.1 Direct pairing
with a Homematic IP device"
on page 45).
Replace the batteries (see
see „8 Changing the batter-
ies" on page 61).
Please see your app for error
message or contact your
retailer.
You can continue once the
test display has stopped.
Wait until the update is
completed.
65