Quick Start - Black+Decker ASI500 Manual De Instrucciones

INTRODUCTION
Intended Use
Your BLACK+DECKER inflation station is designed to
be used cordless or in most vehicles from the standard
12 Volt socket to inflate car and bike tires, balls, rafts, air
mattresses, swimming pool floats, etc. This product is
intended for household, consumer use only.
Charging the Battery (Fig. B)
The internal battery must be recharged for 4 to 5 hours
using the AC charger provided (13).
f Insert the jack plug (9) into the socket on the front
of the unit (11).
f Plug the AC charger into a 220Vac electrical outlet.
f The LED (15) on the AC charger (13) will indicate
the level of charging. Red, unit charging, Green,
unit charged.
f When fully charged, remove the AC charger from the
power source and remove the jack plug from the unit.
Needs Charging
Fully Charged
USE
Hose and Cord Storage (Figs. C, D and E)
f Wrap the 12v dc cord (17) around the base of the unit
and snap the 12 Vdc adapter (8) into its storage
location on the base of the unit (16).
f The air hose (5) is located in a storage channel
around the top of the unit (Fig. D), make sure the hose
is snapped into the retaining clips and the lever is in
the up position (fig.E).
f The pump hose (7) is stored around the center of
the unit and snaps into position at both ends. The
accessories are also stored on the front of the unit.
Fitting the Accessories (Figures E,F,G and H)
Your inflator is supplied with the standard tapered nozzles
and the needle inflator nozzle, these are located on the
front of the unit.
f To use the universal valve adaptor, make sure that
the lever is in the up position.
f Place the valve adapter over the stem of the inflation
needle or tapered nozzle (Fig. E).
f Press the lever on the valve adapter down to lock
it in place.
f Place the inflation needle or tapered nozzle into
the item to be inflated.
Note: Always make sure that the lever is in the up
position when not in use. Operate your inflator only
with the universal valve adaptor or with the included
nozzles.
Charging
Note: Make sure that the universal valve adapter is
firmly locked in place before turning the inflator on.
Your inflator is supplied with a high volume adaptor (24).
This is stored on the front of the unit (fig. F).
f To use the high volume adaptor (24),
remove it from the high volume inflate connection.
f Remove the high volume hose (7) from
the storage location.
f Remove the tapered nozzle (18) from the end
of the high volume hose (7).
f Fit the high volume adaptor (24) to the end
of the high volume hose (Fig. G).
Many inflatables have an internal flap that prevents air loss
during inflation, especially air mattresses. Unless this flap
is displaced by the nozzle the inflatable will not inflate.
Push the nozzle firmly into the valve to make sure that you
push this flap out of the way.
Warning! Risk of Bursting. Excessive air pressure
may cause a hazardous risk of bursting or personal injury.
Check the manufacturer's maximum pressure rating for
items being inflated.
Note: If the pressure rating for the item being inflated
is above 100 psi, note that the maximum run time is 10
minutes, leave to rest for 20 minutes before re-use.
Operating the Inflator (Fig. H)
Warning! Do not operate the inflator when the car
engine is running.
Note: Make sure that your 12Volt accessory socket is live.
On some vehicles the accessory socket may only become
live when the ignition key is in the accessory position.
To power the display from the 12Vdc adapter:
f Always fully extend the 12Vdc cord before each use.
f Connect the 12Vdc adapter (8) into your vehicles
12V accessory socket.
f Switch the main power switch (1) to the inflate
position (c) to power up the LCD.
To power the LCD from the internal battery (cordless operation):
f Switch the main power switch (1) to the inflate
position (c) to power up the LCD.
Warning! Risk of Bursting. Do not leave unit running
unattended. Overinflation of tires and other items could
result in serious injury and property damage.

Quick Start

Warning! Never leave inflator running unattended in
this mode. In can burst car tires and other items.
ENGLISH • 23