Protecting The Environment - Black+Decker ASI500 Manual De Instrucciones

f To start the pump press the power switch (22)
on the LCD.
f When the item is deflated or to stop the pump at any
time press the power switch (22) on the LCD.
f Remove the high-volume hose (7) from the item
and store it in the storage channel around the center
of the unit.
f Turn the main power switch (1) to the off position
(b, Fig. H).
Operating the LED Light
To switch on the LED light (12):
f Switch the main power switch (1) to the inflate
(c, Fig. H) or the pump (a, Fig. H) position.
f Press either of the - or + buttons (21 and 23)
on the LCD (2) to turn the LED light (12) on.
To switch the LED light (12) off:
f Press either of the - or + buttons (21 and 23) again.
f Turn the main power (1) switch to off.
Sleep Mode to Preserve Battery Life
f The unit is fitted with a sleep mode function that will
help prolong the life of the internal battery.
f If the unit is left on and unused for more than
2 minutes the unit will drop into sleep mode.
f To power the unit again either switch the main
power switch (1) on and off or press any button on the
LCD (2).
Note: After sleep mode, all settings will be lost and
will need to be re-entered following the instructions
under the heading "Setting the Automatic Shut-off
Pressure".
Replacing the Fuse in the Vehicle
DC Accessory Plug
f Remove the cap by turning it counterclockwise.
f Remove the center pin.
f Remove the fuse.
f Fit a new fuse of the same type and size (8A / 250V).
f Refit the cap and center pin.
f Tighten the cap by turning clockwise onto the plug.
Battery Removal (for Recycling) (Fig. J)
Warning! Exercise care when handling batteries in
order not to short the battery with conducting materials
such as rings, bracelets and keys. The battery or
conductor may overheat and cause burns.
Before attempting to disassemble the main body of
the product, turn it on and leave it on until the power is
depleted to ensure a complete discharge of the battery.
Using a phillips screwdriver, remove the screws from the
bottom housing cover shown in Fig. J. Lift the battery out
and pull off the terminal clips. See "Service Information"
for battery replacement.
MAINTENANCE
Your tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
SPECIFICATIONS
Charger
Output
ENGLISH • 25
ASI500
220V, AC 50Hz,
0,9 Amperios
12C DC 8 Amperios