Anti-Calc System - UFESA XENON Manual De Instrucciones

ANTI-CALC SYSTEM

A special resin filter inside the water reservoir softens the water and prevents scale build-up in the
plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralized water makes the "Zero-Calc", anti-calc system
ineffective by altering its physicochemical characteristics.
TROUBLE SHOOTING
Problem
Soleplate (9) is not heating even
through iron is turned on.
Steam does not come out
Shot of steam / vertical ironing
function does not work
22
Possible cause
Connection problem
Temperature control (7) is at "MIN"
position
Not enough water in the tank.
Steam regulator (3) is selected in
non-steam position.
Selected temperature is lower than
that specified to use with steam.
Iron is not hot enough.
Selected temperature is lower than
that specified to use with steam.
Solution
Check main power supply cable
plug and outlet.
Turn to a higher position, if
compatible with the fabric.
Fill the water tank.
Set the steam regulator between
positions of minimum steam and
maximum steam.
Set to a higher temperature, if
compatible with the fabric.
Set a suitable temperature and wait
until the pilot light (10) goes out.
Set a higher temperature, if
compatible with the fabric.