Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
valves
spout
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
This faucet requires ½" hot and cold
supply lines (not included).
• 71733XX1, 72130XX1 only: The drain is
suitable for most, but not all, lavatory sinks sold
in the United States and Canada.
• The drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your sink,
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 l/min)
1⅜" (35 mm)
1¼" (32 mm)
1⅜" (35 mm)
please refer to the instructions included
with the sink. Some sinks include special drain
installation instructions and/or parts. Others
require the use of a specialty drain. Hansgrohe
is not respnsible for the cost of a specialty drain.
• 71737XX1 only: This faucet does not include
a drain or a pull rod.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.
Publicidad
