Publicidad
Idiomas disponibles
Idiomas disponibles
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
When the machine is not being used over
a longer period of time it is best to store the
battery in charged condition.
4. OPERATION
Connecting the watersupply
This unit is to be used with a cold-water
source only!
The pressure washer must only be used
with clean water; use of unfiltered water or
corrosive chemicals will damage the
pressure washer.
Ensure that you have a suitable water
supply to feed the pressure washer. Check
that all connections are tight and there are
no leaks in the hose.
You can enable the water supply via a water tank
(or pond, rain barrel, etc.) or via a water tap.
Water tank (water suction function) (Fig. E1)
Clean the suction filter (9) at regular
intervals, and check it for damage.
Otherwise, its function can be impaired.
When water is supplied via a water tank, pond, rain
barrel, etc. , the assembled suction hose (7) must
be used. Only clear fresh water may be used.
1. Connect the assembled suctionhose (7) to the
pressure washer, place the hose connector (5)
on to the water inlet (4).
2. Lower the suction filter (9) into water. Ensure
there are no obstructions around the suction fil-
ter (9). Move the float ball (8) in such a way that
the suction filter (9) does not touch the water
bottom. The suction filter (9) must be placed at
least 20 cm from the water bottom to prevent
the suction of sand. When using a water tank,
WWW.VONROC.COM
rain barrel or bucket, you can secure the hose
by using the bucket clamp (12).
3. Check that the hose has no kinks in it.
4. The pressure washer is now ready for use.
Water tap (Fig. E2)
Use the device on a domestic water
connection with maximum pressure of
5 bar.
The supply tap should be fully open.
1. Ensure that you have a suitable water supply to
feed the pressure washer.
2. Connect the water supply hose (not included) to
to the water inlet (4).
3. Connect the water supply hose (not included) to
the water supply.
4. Turn on water and heck that the hose has no
kinks in it.
5. The pressure washer is now ready for use.
Switching the pressure washer on/off (Fig. A)
The motor of this pressure washer will NOT
run. It will only operate when the trigger is
squeezed.
Before starting make sure the pressure
washer is connected to a water source. Dry
running will damage the pressure washer!
• To start the pressure washer, press and hold the
release button (11) and press the switch lever
(10).
• To stop the pressure washer, release the switch
lever (10).
Adjusting the nozzle (Fig. F)
Water may be sprayed out of the nozzle (3) either
linearly or in a fan shape. Turn on the pressure first,
and then adjust the nozzle (3).
Using detergents (Fig G, A)
The detergent bottle (13) will allow you to apply
many forms of liquid detergent onto the work
surface.
1. Remove the detergent dispenser of the deter-
gent reservoir and fill with liquid detergent only.
Do not put any water into the reservoir. The de-
tergent bottle (13) will mix water and detergent
automatically.
EN
9
Publicidad
