Charging The Battery - sunjoe 24V-HCSWP-CT Manual Del Operador

Charging the Battery

1. Push the push lock buttons on either side of the battery
pack to pull it out from the battery compartment (Fig. 1)
2. Depending on your Snow Joe
model, how to recharge your lithium-ion battery will vary.
You may either insert your 24-volt battery into the
24VCHRG-QC Quick Charger (sold separately) or the
24VCHRG-DPC Dual-Port Charger (sold separately)
(Figs. 2 – 3).
Fig. 2
Charging
red
24VCHRG-QC
quick charger
(sold separately)
Fully
Charged
green
Fig. 1
Push lock button
+ Sun Joe charger
® ®
Battery pack
Fig. 3
Charging
red
Fully
Charged
green
3. The battery indicator LEDs will illuminate one by one
during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual-Port Charger (sold separately)
are also equipped with additional charging indicating
lights that will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the battery from the charger.
m
WARNING!
The charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. Recharge the battery pack when you notice
a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
This cordless pruning saw comes completely assembled
with the guide bar and chain pre-installed. Users simply have
to configure the unit as a hand-held pruning saw or a pole
pruning saw before operation. Follow the instructions below to
connect the machine.
m
CAUTION!
Make sure the battery is not inserted and
the chain are covered by the sheath before assembly.
10
Battery pack
24VCHRG-DPC
dual-port charger
(sold separately)