Publicidad
Idiomas disponibles
Idiomas disponibles
Pole Pruning Saw Operation
1. To extend the pole assembly, lift the cam-lock and extend
the pole to the desired length (Fig. 20). Close the cam-lock
to secure the pole in position.
Fig. 20
Cam-lock
2. The pruning saw can be adjusted into 7 different angles
(-45º | -22.5º | 0º | 22.5º | 45º | 67.5º | 90º) to allow for
greater flexibility and control. To adjust the cutting angle,
push the multi-angle lock button. Then pivot the pruning
saw to your desired angle and release the button. The saw
will click into position and be locked at that angle (Fig. 21).
-45°
-22.5°
0°
22.5°
45°
90° 67.5°
3. Insert the battery as shown in (Fig. 9).
4. Hold the pole pruning saw with one hand on the handle
and the other on the pole. Always cut adjacent to the
material and never underneath to avoid injury from
falling branches. Adjust the length and angle accordingly
(Fig. 22).
NOTE: Do not raise your bottom hand above chest height
in order to maintain control of the saw in the event of a
kickback.
Fig. 22
Pole
Fig. 21
Multi-angle
lock button
5. To turn on the tool, firmly grip the pruning saw handle
and press the safety lock to deactivate the safety. Then
squeeze the trigger to activate the saw (Fig. 23).
NOTE: Do not squeeze the trigger until you are ready to
make a cut.
Trigger
6. Release the trigger to stop the saw.
Maintenance
Please contact an authorized Snow Joe
or call the Snow Joe
+ Sun Joe
®
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
WARNING!
For your safety and that of others:
• Keep all nuts, bolts, and screws tight to be sure the
equipment is in safe working condition.
• Never use the machine with worn or damaged parts.
Damaged parts are to be replaced and never repaired.
• Only use original Snow Joe
parts. Parts that are not of the same quality can seriously
damage the equipment, compromise safety, and invalidate
the warranty.
• Remove the battery and wait at least five minutes for the
saw to cool before servicing or storing your unit.
• If you drop the saw, carefully inspect it for damage. If the
guide bar is bent, the housing is cracked, the handle is
broken, or if you see any other damage that may affect the
saw's operation, do not use the tool.
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless pruning saw.
15
Fig. 23
Safety lock
+ Sun Joe
dealer
®
®
customer service center
®
+ Sun Joe
replacement
®
®
Publicidad
