Installation And Connection - Vertex Life Takashi Manual De Instrucciones

installing the cooker, it must be verified that the load-bearing capacity of the floor
where it is to be installed is sufficient for the cooker. In case of insufficient load-
bearing capacity or low lifting capacity, appropriate precautions must be taken
(e.g., placing a cooker lifting plate).
3. SECURITY
THE VENTILATION CONDITIONS OF THE PLACE WHERE THE PRODUCT IS TO BE
INSTALLED AND PROTECTION AGAINST FREEZING MUST BE TAKEN INTO
ACCOUNT.
All required standard tests are tested for this product. The expected parameters
associated with combustion efficiency and flue gas emissions are observed. The
cooker type described in this manual has been tested according to BA 1, DIN 1881
EN13240, by an approved body.
The combustion chamber lid must only be opened for fueling. To avoid hazards,
the combustion chamber must be closed. For efficient operation of the cooker,
there must be a minimum flow of fresh air into the room where it is installed.
The combustion of combustible materials generates thermal energy which heats
the cooker surfaces (doors, door handles, flame monitor cover, side walls, front
wall). These parts must not be touched without heat protective gloves.
CAUTION! As the top surface of the cooker may be hot, do not place
combustible materials on it.
Hazardous materials (plastic, flammable substances, etc.) can cause fires in the
chimney. In this case, immediately close all parts of the cooker and call the fire
brigade.

4. INSTALLATION AND CONNECTION

The packaging of the cooker protects the product against damage in the best
possible way. However, the cooker or its accessories may still be damaged during
transport. Therefore, at the time of delivery, remove the cooker from the package
and check whether it is complete and undamaged. In case of any damage, report
it on the carrier's ticket or at your point of sale.
4