Descargar Imprimir esta página

VONROC HR502 Serie Traducción Del Manual Original página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
figure B1.
2. Place the plugs (7) in the drill holes.
3. Align the holes of the bracket (2) in front of the
plugs (7).
4. Mount the washer (9) and screw bolt (8)
through the bracket into the wall/plugs.
5. Tighten the screw bolts (8) by using a wrench.
6. Place the caps (10) over the screw bolts (8).
4. OPERATION
Before using (Fig. A, C)
1. Mount the hose box (1), as shown on figure C1.
2. Connect the spray nozzle (4), as shown on figu-
re C2.
3. Connect the water supply hose to the water
supply, as shown on figure C3.
4. Check that the hose has no kinks in it.
5. Pull the hose and stop when it reaches the desi-
red length. The maximum length is 25 meters.
6. Turn on water and check for leaks.
7. The automatic hose reel is now ready for use.
After using (Fig. A, D)
Do not leave the hose unrolled. After use,
the water must be turned off and the hose
drained. The hose must be rolled up to
prevent damage to the hose and spring.
Hold the spray nozzle (4) when the hose is
retracting and follow the retraction until it
finishes.
When retracting, the hose must be
straightened. If the hose gets twisted,
extract it fully and retract it slowly to
smoothen out the hose.
1. Turn off the water.
2. Drain the water from the hose.
3. Clean the hose with a soft cloth, preferably after
each use.
4. Extract the hose about 5-16 cm, as shown on fi-
gure D. The hose will retract automatically. Hold
the spray nozzle (4) when the hose is retracting
and follow the retraction until it finishes.
5. Disconnect the spray nozzle (4).
6. Disconnect the supply hose from the from the
water supply.
7. Remove the rotating shaft (3) and remove the
hose box (1).
WWW.VONROC.COM
8. Put the rotating shaft (3) back into the hole and
push the hose connector of the supply hose
onto the rotating shaft.
9. The hose box is now ready for transport and
storage.
5. MAINTENANCE
Cleaning
• Never submerge products in water while cle-
aning.
• Do not use cleaning agents or solvents. Wipe
the device using a soft cloth.
• Clean the hose regularly with a soft cloth, pre-
ferably after each use.
Storage
The automatic hose reel should be kept in a safe,
dry place, well out of the reach of children. Do not
place other objects on top of it.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or im-
properly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
EN
5

Publicidad

loading