Cutting Depth Setting - Mafell MT55 18M bl Instrucciones De Funcionamiento Y Seguridad

MT55 18M bl

5.4 Cutting depth setting

The cutting depth can be set continuously in a range between 0 and 57 mm [0 to 2.24 in].
Use the following procedure to set the cutting
depth:
1. Rotate the pointer (1) depending on whether or
not you are working with a guide rail (optional
accessory).
Top position = with guide rail
➢
Bottom position = without guide rail
➢
The cutting depth is reduced by 6 mm [0.24 in] when
a guide rail is used.
2. Use the pointer (1) to set the cutting depth.
The cutting depth is indicated on the scale
➢
(2) on the cover. The scale has a 1-mm
graduation.
To readjust the cutting depth setting, you
➢
can use the Allen key (B) to turn the fillister
head screw (21). One revolution
corresponds to a cutting depth change of 1
mm [0.04 in].
The cutting depth is set.
✓
For separating cuts, always set the
cutting depth to approx. 2 ... 5 mm
[0.08 ... 0.2 in] more than the
material thickness you want to cut.
01/2022
Fig. 15: Cutting depth pointer position
Fig. 16: Setting the cutting depth
19