Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
SELF-CLEANING BRUSHROLL
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair
wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
To access the brushroll, push up on the tabs on the
brushroll door, then lift off the door.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
Lift out the brushroll and remove any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll door and press down until both
sides click into place.
s h a r kc l e a n . e u
MAINTENANCE
CLEANING SENSORS AND CHARGING CONTACTS
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the base.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
CLEANING SIDE BRUSH
CLEAN SIDE BRUSH AS NEEDED.
NOTE: Remove and replace the side brush if it is bent or damaged. To remove the brush, lift it off its peg.
s h a r kc l e a n . e u
Carefully unwind and remove any string or hair
wrapped around the side brush.
Gently wipe brush with a dry cloth. To reinstall, snap
the brush over the pegs. Spin the brush manually to
make sure it is installed correctly.
NOTE: Side brush design may vary.
Publicidad
