Publicidad
Step 13
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown
in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the LEFT UPRIGHT (B) and LEFT END (E). Use
four SILVER 1/2" FLAT HEAD SCREWS (128S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole
that lines up with the hole in the UPRIGHT and END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the FILE DRAWER.
å
Fasten the L-LOCK BRACKET (76G) to the LEFT UPRIGHT (B) exactly as shown. Use two
BLACK 9/16" LARGE HEAD SCREWS (1S).
40MC
Push the black lever in and pull the SLIDE from the RAIL.
Open end
www.sauder.com/service
128S
SILVER 1/2" FLAT HEAD SCREW
(4 used for the RAILS)
E
2
1
BLACK 9/16" LARGE HEAD SCREW
B
4
3
427163
40MA
1S
(2 used for the BRACKET)
76G
1
2
3
4
7
Open end
Page 19
Publicidad
