Publicidad
Step 40
1
D133
K
Groove
å
Insert the DRAWER SIDES (D133 and D139) at an angle
into the slot at each end of the DRAWER FRONT (K).
3
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D77
D133
å
Fasten the DRAWER BACK (D77) to the DRAWER
SIDES (D133 and D139). Use four BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
Page 46
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D139
30S
(4 used in this step)
Be sure the
DRAWER
BOTTOM
D139
inserts into
the DRAWER
BACK groove.
2
D133
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D708) into the
grooves in the DRAWER SIDES (D133 and D139)
and DRAWER FRONT (K).
4
BLACK 9/16" LARGE HEAD SCREW
(2 used for the Z-LOCK BRACKET)
77G
å
Fasten the Z-LOCK BRACKET (77G) to the DRAWER
FRONT (K) exactly as shown. Use two BLACK 9/16"
LARGE HEAD SCREWS (1S).
427163
With the palm of
your hand, tap the
DRAWER BOTTOM
U n fi
down into the groove.
n i s h
s u r
e d
f a c
e
D708
D139
K
1S
K
www.sauder.com/service
9
Publicidad
