brondell Swash CL2200 Manual Del Propietário página 13

5. Installing mounting plate
a. Wet the rubber anchors with water,
squeeze the sides of the anchors, and
firmly press them all the way down into
the mounting holes on top of the toilet.
TIP: Wetting the rubber anchors will
allow for easier installation. The top of
the anchors should be flat to the surface.
Step 5a
b. Place the mounting plate over the rubber
anchors on the toilet.
c. Place the adjustable brackets flat side
down on the mounting plate over the
rubber anchors.
d. Insert the washers and metal mounting
bolts through the adjustable brackets
and rubber anchors; use a Phillips
screwdriver to screw in the mounting
bolts and tighten.
NOTE: Depending on the adjustable
brackets included with your bidet
seat, washers may not be required for
installation and were not included. If
the washers have not been included,
proceed with mounting the seat without
the washers.
Steps 5b–5d
6. Insert the deodorizer cartridge into the back
of the bidet body and attach the deodorizer
cover until it snaps into place.
Step 6
Continued following page
13