Technical Information; Troubleshooting - brondell Swash CL2200 Manual Del Propietário

TECHNICAL INFORMATION

Troubleshooting

If the bidet appears to be operating
abnormally, please review the troubleshooting
tips before calling the Brondell Service Center,
as most issues are easily resolved with a few
simple steps. If you are unable to resolve
the issue after checking the following items,
please call the Service Center at 888-542-
3355, Mon–Fri, 9am–5pm PST, or email us at
support@brondell.com.
Problem Possible Cause(s)
The bidet seat is 1. Bidet not plugged in
not working
2. Water supply valve not
3. No power to bidet
4. The incoming water is too hot
5. Seat sensor is not activated
Product shuts off 1. Washing time exceeded the
during use
2. Power failure
3. Seat sensor is not activated
Nozzle does not 1. Nozzle is dirty
function properly
2. Clogged filter
3. Water pressure is too low
4. External bidet filter
opened fully
cycle time
Check before continuing:
Make sure the bidet seat is connected to
power and that the outlet is working properly.
Make sure you check & test the reset button
on the GFCI outlet (Standard 120V GFCI
outlet).
Make sure the main water supply valve
is open.
Make sure the seat is not in standard or high-
efficiency eco mode.
Confirm that there are no leaks from the hoses
or water supply.
Make sure the mesh filter is clean and free of
build-up or debris (see maintenance section
on page 27).
After checking items above, refer to the
following troubleshooting chart for additional
solutions.
Solution(s)
1. Make sure the bidet is plugged in
2. Check that the water supply valve at
the wall is fully open
3. Check and reset GFCI outlet
4. Ensure that the bidet seat is
connected to the cold-water supply
5. Adjust sitting position to fully cover
the seat sensor
1. Wash cycles run for 2 minutes. Press
the wash button after the wash has
finished to continue the wash cycle
2. Check and reset GFCI outlet
3. Adjust sitting position to fully cover
the seat sensor
1. Clean the nozzle (see page 26)
2. Remove, clean, and reinstall mesh
filter (see page 27)
3. Check that water supply valve at wall
is fully open
4. If you have an external bidet filter,
check and replace if necessary
29