Connecting Piece F-Vs (Optional Accessories); Sliding Bevel F-Wa (Optional Accessories) - Mafell F80 Instrucciones De Montaje

4

Connecting piece F-VS (optional accessories)

The connecting piece F-VS serves to connect two guide rails. All rail lengths can be combined with each other.
For storage purposes, the connecting piece can be completely slid into the rail.
5

Sliding bevel F-WA (optional accessories)

The sliding bevel F-WA allows bevel cuts between - 45° and 60° to be performed. The sliding bevel F-WA can
be connected with any guide rail F with a connecting piece F-VS.
For bevel cuts, follow the procedure below:
1. Set the degrees for the bevel cut by means of
the scale (5) fasten the locking device (6).
2. Align the sliding bevel with the workpiece.
3. Cut the workpiece with the set angle.
Bevel cut performed.
✓
In the 90° position, the rail length of the sliding bevel F-WA is 200 mm [7.87 in].
With the setting on 0°, push the pointer into the notch with your thumb, keep depressed
and fasten the locking device.
Fig. 2: Setting for bevel cuts
-7-