Publicidad
Idiomas disponibles
Idiomas disponibles
To operate the product
•
To operate the product forward, move the control for
forward and rearward movement (B) forward.
A
B
•
To operate the product rearward, move the control
for forward and rearward movement (B) rearward.
•
To start the vibration, move the vibration control (A)
to the ON position.
•
To stop the movement of the product, release the
control for forward and rearward movement.
•
To stop the movement of the product in an
emergency, push the emergency stop button (C).
Note:
The movement stops also if the control for
forward and rearward movement is in the forward or
rearward position.
To stop the product
1. Park the product on level ground.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
1503 - 002 - 15.07.2022
C
Maintenance
Read and understand the
2. Press the stop lever to stop the engine.
3. If the engine has an electrical start, also do these
steps:
a) Turn the ignition key to the stop position.
b) Remove the ignition key to prevent accidental
start.
X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
Before use,
Weekly,
each 10 h
each 100 h
*
X
*
Monthly,
Yearly, each
each 250 h
500 h
11
Publicidad
