Safety Warnings - KRHÜNER 51026 Manual De Instrucciones

1. SAFETY WARNINGS

- This appliance is not intended for being used by children from 0 to 8 years old. This ap-
pliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should not play with the appliance. Clean-
ing and maintenance shall not be performed by children.
- For additional protection, the installation of a residual current device (RCD) having a
rated residual operating current not exceeding 30mA is advisable in the electrical cir-
cuit. Ask your installer for advice.
- If the power cord is damaged, in order to avoid risks, it should be replaced by the man-
ufacturer, maintenance department or similar sector professionals.
- This appliance is not intended to be operated by means of an external timer or separate
remote-control system.
- Only the appropriate connector must be used.
- Do not use attachments not recommended or supplied for this product.
- Disconnect the appliance from the power supply if it is left unattended and before as-
sembling, disassembling or cleaning.
- Use the iron only for its attended use.
- To protect against the risk of electric shock, do not immerse the iron in water or other
liquids.
- Do not turn on the LED strip when it is wound on the spool.
- The LED strip can only be cut by the brand that is printed on the strip itself.
- During installation, bend the strip to the side so that 2-3 mm of the copper wire that
has the strip on the sides is showing, so that you can make a clean cut and avoid the
danger of short circuit.
- Connect the feeder to the mains once you have completed the entire connection and
installation process.
- If you install in a cold working temperature, the strip will be very stiff and may break.
You can connect the strip for a few minutes, so with the increase in temperature gen-
erated by its operation, you can make the strip more flexible and you can work on your
installation more easily.
- Do not hit or subject the led strip to vibrations during installation and use. It can ad-
versely affect its proper functioning.
- At the end of the strip you need to install the end piece and fix it firmly before connect-
ing it to the mains.
ENGLISH