Osd (On Screen Display) Menu Settings; Mute Function; How To Access Programming Mode - Urmet 1760/6 Manual De Usuario

4. ANSWERING THE CALL
When an external video door phone call is received, the video door phone rings and the screen lights up.
Press the key to answer the call (the key LED starts flashing). Press the key again to terminate the call
and the display switches off.
5.

OSD (ON SCREEN DISPLAY) MENU SETTINGS

To access the OSD menu, press the
Press the button briefly to scroll in sequence through the three parameters in sequence:
1) BRIGHT
2) CONTRAST
3) COLOR
These parameters are adjusted using the
value of each parameter (for further details see the table "KEY FUNCTION").
6.

MUTE FUNCTION

This function can be used to mute the ring tone on the video door phone and any connected supplementary
ringers. The function can be activated in two different ways :
• MUTE 8h: Hold button
In the event of a power failure, the MUTE 8h function will restart from zero as if it had just been
activated .
• MUTE (no time limit): by pressing the
until the button is pressed again .
After any power failure the function will keep the state it had before the event.
When the "MUTE" function is active all beeps are also disabled.
7.

HOW TO ACCESS PROGRAMMING MODE

To enter device programming mode, press and hold the
seconds) while the device is in stand-by.
Access to the programming mode is confirmed by three short beeps and by the visual indication of the
key LED, which starts flashing in orange.
The programming mode can be exited by pressing the
confirmed by 2 long beeps and by the LED on the
status (see chapter "LED status signalling").
The device automatically closes programming mode after 10 minutes from access.
10
key during a video call or in auto-on mode.
and
3
pressed to mute the video door phone for up to 8 hours.
3
button for a short time the video door phone will be muted
keys which increase or decrease the adjustment
button for an extended period (more than 5
key for a long time. The operation will then be
key which will stop flashing, returning to its previous
DS1760-010