Publicidad
Idiomas disponibles
Idiomas disponibles
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
Pressure Washer Rinsing
For Rinsing:
1.
Slide the nozzle backward to high pressure, press the
trigger and wait for the detergent to clear.
NOTE: You can also stop detergent from flowing by simply
removing chemical injection hose from bottle.
2.
Keep the spray gun a safe distance from the area you
plan to spray.
High pressure spray could cause you to fall if
you are too close to the cleaning surface.
• Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
3.
Apply a high pressure spray to a small area, then check
the surface for damage. If no damage is found, it is okay
to continue cleaning.
4.
Start at the top of the area to be rinsed, working
down with same overlapping strokes as you used for
washing and applying detergent.
SpeedClean™ 2000 PSI Pressure Washer
WARNING
www.mymowerparts.com
Cleaning Chemical Injection Hose
If you used the chemical injection hose, you must flush it
with clean water before stopping the engine.
1.
Place chemical injection hose in a bucket full of clean
water.
2.
Slide adjustable nozzle forward to low pressure
position. Flush for 1-2 minutes.
3.
Shut off engine.
IMPORTANT: Simply shutting OFF engine will not
release pressure in the system. When the engine has
shut down, squeeze the trigger on the spray gun to
relieve the pressure in the hose.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging the warm water onto the ground.
12
Publicidad
