Led Signals; Tool Indicator Led; Remote Leds; Oled Screen - Greenlee ES20LXR Manual De Instrucciones

LED Signals

Signal
Red LED stays lit for 20 seconds after
trigger is released.
LED will flash for 20 sec. after trigger is
released.
Flashing light for 20 sec. at end of cycle.
Signal
Blue light flashes. Green remains off.
Blue light solid. Green remains off.
Green light flashes and blue light is solid.
Green and blue lights both flash.
Green and Blue LEDs solid.

OLED Screen

The OLED screen displays information about the tool and is used to set up operating profiles and display error codes
in the event of abnormal operation (See Troubleshooting). Turn on the screen by inserting the battery and pressing
the trigger.
Cycle through the various displays using the left and right buttons on either side of the screen. The screens will not
cycle after the remote is paired with the tool.
Display
0
P
1
^
P
FW:
2
CURRENT USER : 1
SINGLE CLICK
3
MRS+
#ODS #DAYS
4
TOTAL:
t=
5
Q=
n=
10
Table 1: Tool Indicator LED Signals
LED (Red)
Table 2: Remote LED Signals
Green
OLED Screen
XXX PSI
Wireless status, battery charge, current pressure, max. pressure. Press and hold both
buttons to change units, select with right button, and confirm by jogging the tool.
XXX PSI
INFO
2.0
123456AB001
1.35 h Elapsed operating hours (T), Ah used (Q), and number of cycles (n) since date of
8.87 Ah
1560
© 2022 Greenlee Tools, Inc.
Meaning
Battery Charge Low
Motor current exceeds 20 A during
cycle
Tool is Overheated
Internal Error
LED
Blue
Information Shown
Firmware version, serial number
Profile Mode Select screen to choose between Remote and Handheld profile
Cycles and days until next service.
Action
Change or charge the battery.
Let tool cool.
Send in for Service.
Action
Searching for wireless signal.
Wireless signal found and paired.
Tool blade is moving.
Remote battery is low.
Cut is complete.
(Only for products equipped with end position sensor)
operations.
manufacture.
ES20LXR
52093315 REV 0