Publicidad
Technical specifications
Code
Description
Voltage
Frequency
Current
Power
Speed
Grindstone diameter
Drill bit size
Conductors
Insulation
Work cycle
WARNING
• If the power cord is damaged, do not use the sharpener and take it to an Authorized
Service Center in order to avoid any risk of shock or major accident.
• Do not expose the cable to rain, liquids and/or moisture.
Power Requirements
WARNING
Tools with double insulation and reinforced insulation are built
with a polarized plug (one prong is wider than the other) This plug fits in any
polarized outlet and can only be connected one way. If the plug does not fit
completely into the outlet, reverse the plug. If it is not fitting, call a qualified
electrician or install a polarized outlet. Do not alter the plug in any way. Double
insulation eliminates the need of a three-prong grounded power plug or a
grounded electric system.
WARNING
When using an extension cable, verify the gauge is enough for the power that your product needs.
A lower gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The following table
shows the right size to use depending on cable's length and the ampere capability shown in the tool's nameplate.
When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING
When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
18 AWG x 2C with insulation temperature of 221 °F
Class II
3 min of work for 7 min of rest. No maximum daily use.
The construction class of the tool is: Reinforced insulation.
Thermal insulation class of the motor windings: Class B
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
AFB-118
101684
Drill Bit Sharpener
127 V
60 Hz
0.66 A
100 W
1 500 RPM
ø 3"
3 mm - 13 mm (1/8" - 1/2")
IP Grade
The power cable is Y - type cable clamp
Extension gauge
from 5.9' to 49.2'
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
IP20
|
higher than 49.2'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3
Publicidad
