Safety Regulations - EINHELL TE-TC 920 UL Manual De Instrucciones

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Special information about the laser
Danger! Laser radiation
Do not look into the beam
Laser class 2
VORSICHT ! - LASERSTRAHLUNG !
Nicht in den Strahl blicken!
Laserspezifikation
Laser Klasse 2; LMM650P01
: 650 nm; P
nach EN 60825-1: 2014
•
Do not look directly into the laser beam with
the naked eye.
•
Never look directly into the laser path.
•
Never direct the laser beam at reflecting sur-
faces, persons or animals. Even a low output
laser beam can inflict injury on the eye.
•
Caution: It is vital to follow the work procedu-
res described in these instructions. Using the
tool in any other way may result in hazardous
exposure to laser radiation.
•
Never open laser module.
•
When the tool is not going to be used for an
extended period of time, the batteries should
be removed.
0
GB
Additional safety instructions
•
Place the machine on a level and stable sur-
face that is free of obstacles (apart from the
materials to be cut) and is well illuminated.
Make sure that the machine does not wobble.
•
Check that the voltage on the rating plate is
the same as your supply voltage. Only then
are you to insert the power plug in the socket-
outlet.
•
Wear safety goggles.
•
Wear ear-muffs.
•
Wear safety gloves.
•
Never use cracked diamond cutting wheels.
Replace immediately.
•
Connect the coolant supply to the water
pump each time before use. See the section
"Fitting the cooling water pump" under point 5
"Before use".
•
Use only water as coolant.
•
Each time before use, check the cooling
water hoses and the cooling water pump for
cracks or damage.
•
Replace the cooling water when the water be-
comes too dirty and the cooling water pump
filter is no longer so effective.
•
Also clean the container in which the cooling
water pump is fastened.
•
Never use segmented cutting wheels.
•
Caution! The cutting wheel runs on after the
machine is switched off!
•
Never apply side pressure to the diamond
cutting wheel in order to bring it to a halt.
•
Notice! The diamond cutting wheel must be
cooled with water at all times.
•
Always pull out the power plug before chan-
ging the cutting wheel.
•
Use only suitable diamond cutting wheels.
•
Never leave the machine unattended in
rooms with children.
•
Always pull out the power plug before exami-
ning the electric motor compartment system
•
Disorder in the work area can easily lead to
accidents.
•
Make sure that you stand squarely and solidly
while working. Avoid abnormal body positions
and always keep your balance.
•
If the cutting wheel becomes jammed, switch
off the equipment and disconnect it from the
power supply; only then are you to remove the
workpiece.
•
Choose an operating position which enables
you to reach all the control elements and pro-
vides a good view of the cut.
- 21 -