Amp Device Mode - ARCA AV40 Manual

AMP Device Mode

The Device Mode button configures the remote to
control the Receiver. Pressing this button does not affect the
currently selected input on the Receiver.
The functionality of the remote is context sensitive for the
internal sources and is described in the following table.
Single press – Toggles Receiver power
2
between standby and on in the current zone
(zone in which the command is received).
Press and hold – Forces all zones into standby,
regardless of which zone the command was
received in.
The number keys can be used for direct entry
0......9
of numeric values
Sync. Delays may be introduced into the video
SYNC
signal by video processing which causes a
mismatch between the audio and video timing.
You will notice this by speech sound being out
of synchronization with the lip movements
in the video. To compensate for this, you can
adjust the lip sync delay. Press the
and use the < and > navigation buttons.
Press again to exit the lip sync trim menu.
Info cycles through the information displayed
INFO
on the lower left portion of the front panel
display when on and inputs.
,
Brings up the DTS:X dialogue control adjustment.
Displays the unit's setup menu on the On
MENU
Screen Display.
Toggles Dolby Audio Processing.
POP UP
AUDIO Toggles Dirac Live EQ on/off.
RTN Brings up a temporary subwoofer trim control.
Use the < and > navigation buttons. Press
again to exit the sub trim control. As this
is a temporary adjustment, the sub trim level
is reset to the value set in the Speaker Levels
menu when the unit is turned off or put into
standby.
Toggles the mute function of the AVR.
Adjust amplifier volume.
VOL
MODE Cycles through the available surround and
downmix modes.
Cycles through the front panel display's
DISP
brightness options
button
AMP Resets remote to mode.
AMP
Stereo direct on/off. Provides a direct analogue
DIRECT
path from the analogue inputs to the left and
right front outputs. Switches off any surround
processing modes and shuts down the DSP
circuits for the best stereo sound quality.
Navigate the files and menus on the screen.
selects the highlighted file or enters the
OK
highlighted menu on the screen – equivalent
to 'Enter' or 'Select' on some remote controls.
' Up
< Left
> Right
, Down
+ ' Power on from standby
AMP
+ , Standby from Power on
AMP
+ select Zone 2
AMP OK
RED Red button.
Green button.
GREEN
Yellow button.
YELLOW
Blue button.
BLUE
Tuner input.
RADIO
AUX Aux input.
NET input.
NET
BT input.
BT
AV input.
AV
SAT input.
SAT
PVR PVR input.
Game console input.
GAME
BD input.
BD
CD input.
CD
STB input.
STB
UHD UHD input.
EN-24
Network commands
When using the network client, the keys below are used to
navigate music files in Device Mode.
AMP
Selects the previous/next track in the current
9
playlist.
:
Pause and playback of the current track.
4;
Stops playback.