WARNING:
To prevent serious personal injury or
damage to the unit, make sure the nozzle is properly
installed before operating the unit.
WARNING:
To prevent serious personal injury, take the
following steps before installing or removing nozzles:
• Stop the unit and allow the impeller to come to a
complete stop
• Disconnect the spark plug wire or disconnect the unit from
the power source before installing or removing nozzles.
WARNING:
To prevent serious personal injury, do not
insert hands into the nozzles or housing when removing or
installing nozzles.
INSTALLING A NOZZLE
1. Align the button on the inside of the nozzle with the groove on
the housing (Fig. 1).
2. Push the nozzle onto the housing and turn the nozzle clockwise
until it locks into place (Fig. 2).
NOTE: The button should face up when the nozzle is properly
installed.
REMOVING A NOZZLE
1. Turn the nozzle counterclockwise approximately 45˚ until the
button unlocks from the housing (Fig. 2).
2. Pull the nozzle off of the housing (Fig. 2).
ASSEMBLY
Housing
6
Groove
Button
Nozzle
Fig. 1
Lock
Unlock
Fig. 2