Ruby RFC-2000 Manual De Instrucciones página 20

INSTALLATION
Tools Needed:
* Pencil *Hammer
A wall mounting bracket is provide with the heater which has been specifically designed to
allow this product to be fitted to a wall or ceiling before drilling the holders for the
wall/ceiling is solid and that there are no hidden water pipes or electric wires. The heater
must be installed no less than 16'' from side walls and no less than 6"' off the floor.
Important: Ensure that the supply cables is well mounted and that it does not come into
contact with reflector of the heater or that does not trail into heated area, the supply cable
can be fixed to the metal mounting bracket behind heater with plastic zip ties.
1. This heater should be installed by a competent person, i.e. a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before
installation.
3. This heater can be mounted in a horizontal or vertical manner.
4. For both wall and ceiling mounting, the lowest part of the heater must be located at or
above a minimum height of 1.8m from ground level, so that the heater can not be
touched when in operation.
5. When mounting horizontally or to a ceiling, do not position the heater at an angle more
than 90°and less than 45°as shown in Fig. A and B.
6. The supply cable must be at the lower end of the heater if the heater is installed at an
angle or vertically.
7. Keep the supply cord away from the body of the heater which will get hot during use.
8. Do not install the heater on an inflammable surface.
9. Observe the minimum safe distance between the heater body and the inflammable
surfaces when mounted.
10. The heater should always have a minimum clearance of 0.5m from a ceiling and
adjacent walls.
11. If the heater is to be used outside, a weatherproof outlet is recommended.
12. Before drilling ensure that there are no wires or water pipes in the area where the
heater is to be installed.
13. The heater must be installed on the mounting brackets provided.
14. Fasten the brackets securely to the mounting surface and the backside of the heater
using the nuts and screws supplied.
15. Fasten the heater securely on the brackets using the nuts and bolts supplied.
*Level *Screw Driver *Power Drill and drill bits
20