Publicidad
Idiomas disponibles
Idiomas disponibles
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins have
been included with your snow thrower. There are holes provided in the
plastic dash panel for convenient storage of the shear pins. Push the
pins through the holes in the dash panel and secure with the bow-tie
cotter pins. See Fig. 8.
Tire Pressure (Pneumatic Tires)
WARNINg
Under any circumstance do not exceed manufacturer's recom-
mended psi. Equal tire pressure should be maintained at all times.
Excessive pressure when seating beads may cause tire/rim
assembly to burst with force sufficient to cause serious injury. Refer
to sidewall of tire for recommended pressure.
The tires can be over-inflated for shipping purposes. Check the tire
pressure before operating the snow thrower. Refer to the tire side wall
for manufactures's recommended psi and deflate (or inflate) the tires
as necessary.
NOTE: Equal tire pressure is to be maintained at all times for perfor-
mance purposes.
Fuel Recommendations
Use automotive gasoline (unleaded or low leaded to minimize combus-
tion chamber deposits) with a minimum of 87 octane. Gasoline with
up to 10% ethanol or 15% MTBE (Methyl Tertiary Butyl Ether) can be
used. Never use an oil/gasoline mixture or dirty gasoline. Avoid getting
dirt, dust, or water in the fuel tank. DO NOT use E85 gasoline.
•
Refuel in a well-ventilated area with the engine stopped.
Do not smoke or allow flames or sparks in the area
where the engine is refueled or where gasoline is
stored.
•
Do not overfill the fuel tank. After refueling, make sure
the tank cap is closed properly and securely.
•
Be careful not to spill fuel when refueling. Spilled fuel
or fuel vapor may ignite. If any fuel is spilled, make sure
ASSEMBLY
ASSEMBLY
Figure 8
the area is dry before starting the engine.
•
Avoid repeated or prolonged contact with skin or breath-
ing of vapor.
Adding Fuel
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running. Extinguish cigarettes,
cigars, pipes and other sources of ignition.
Always keep hands and feet clear of equipment moving parts. Do not
use a pressurized starting fluid. Vapors are flammable.
1.
Clean around fuel fill before removing cap to fuel.
2.
A fuel level indicator is located in the fuel tank. Fill tank until fuel
reaches the fuel level indictor, Figure 9. Be careful not to overfill.
Checking Oil Level
The engine is shipped with oil in the engine. You must, however,
check the oil level prior to operating the snow thrower. Running the
engine with insufficient oil can cause serious engine damage and
void the engine warranty.
Some engines will have a quarter-turn oil fill/dipstick cap, others may
have a threaded oil fill/dipstick cap. Follow the instructions next that
apply to your engine model.
10
10
WARNINg
WARNINg
Fuel Level Indicator
Top View
Figure 9
CAUTION
Publicidad
Solución de problemas
