Publicidad
Idiomas disponibles
Idiomas disponibles
Chute Assembly
Drift Cutters
Clean-out Tool
Augers
Now that you have set up your snow thrower, it's important to become
acquainted with its controls and features. Refer to Figure 16.
SPEED SELECTOR SHIFT LEVER
The speed selector shift lever is located on the right side
of the handle panel. Place the speed selector shift lever
into any of eight positions to control the direction of travel
and ground speed.
Forward
Your snow thrower has six forward (F) speeds. Position
one (1) is the slowest and position six (6) is the fastest.
Reverse
Your snow thrower has two reverse (R) speeds. One (1) is
the slower and two (2) is the faster.
Craftsman Snow Throwers conform to the safety standard of the American National Standards Institute (ANSI).
OPERATION
Speed Selector
Shift Lever
Drive Control
Headlight
Auger
Housing
Skid Shoes
Figure 16
Meets ANSI Safety Standards
Two-way Chute Control™
Auger Control
Wheel Steering Control
Chute
Directional
Control
Oil Filler
Cap/Dipstick
Primer
Key
Choke
Throttle
Oil Drain
CHOkE CONTROL
The choke control is found on the rear of the
engine and is activated by rotating the knob
counter-clockwise. Activating the choke control
closes the choke plate on the carburetor and aids
in starting the engine.
kEY
The key is a safety device. It must be fully inserted
in order for the engine to start. Remove the key
when the snow thrower is not in use.
NOTE: Do not turn the key in an attempt to start
the engine. Doing so may cause it to break.
14
Gas Cap
Electric
Start
Button
Electric
Starter Outlet
Recoil Starter
Handle
Publicidad
Solución de problemas
