Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Support
Angled assembly where the device hangs from a vaulted or angled ceiling.
Angled assembly
Support
Mounting bracket assembly
Wooden ceiling
Fig. 4.
Use the 4 provided self-tapping screws with its corresponding 4 washers to fix the mounting
bracket to the ceiling.
Concrete ceiling
Fig. 5.
1.
Drill 2 8-mm holes on the concrete ceiling.
2. Cover the surface of the bolt with epoxy resin and introduce them in the drilled holes.
3. Let them sit for the time indicated on the product's box.
4. Then, introduce the visible part of the bolts in the mounting plate's holes.
5. Fix the mounting plate to the bolts by screwing first the regular washer, then the lock
washer and finally the nut.
Hanging the fan
Fig. 6.
Electric wiring
Canopy
Decorative cover
Hanging ball slot
Stop pin
Stop pin clip
Adapter
Screws
Note:
If you wish to extend the fan's hanging length, remove the hanging ball from the downrod
provided and use the extended down rod (included).
1.
Remove the hanging ball from the down rod by loosening the screws in it and remove the
stop pin's clip and the stop pin.
2. Slide down the hanging ball from the original down rod to remove it.
3. Pass the desired down rod through the decorative cover's centre hole and then introduce
it in the hanging ball again. Make sure the hanging ball is placed in the end with 2 pin
holes and 1 screw hole.
40
ENERGYSILENCE AERO 5200 WHITE/BLACK LINE
4. Use the screws provided to tighten back the hanging ball to the rod and insert the stop
pin and stop pin's clip again.
Note:
Make sure the stop pin is aligned with the slots inside the hanging ball.
5. Loosen the screws and nuts on the top part of the motor housing and remove the pin and
clip from the down rod.
6. Slide the down rod through the canopy.
7.
Pass the cables through the down rod. To do it more easily, it is recommended to apply
some rated electrical tape on the end in order to keep them together while passing
through the down rod. Carefully pull from the cables to ensure there is enough cable
length to continue with the assembly.
8. Introduce the down rod in the motor housing's hole and reinsert the stop pin and stop
pin's clip that were previously removed.
9. Use 2 screws to fix the canopy to the motor housing.
Warning:
The important safety precautions and instructions stated in this manual are not meant to
cover all possible conditions and situations that may occur. Bear in mind that common sense
and caution are necessary factors in the installation and operation of this fan.
Cable connection
The connection cables coming out from the down rod and hanging ball must be connected
following the below diagram.
Fig. 7.
0. Ground wire
1. L
2. N
1. Input L (black)
2. N input (white)
Remote control receiver
Cable instructions
-
Before handling the cables, make sure all the poles are disconnected from the power
supply.
-
The fan includes a remote control unit with radio frequency, it does not have a speed
control chain. It can only be controlled through the remote control inside the box.
ENGLISH
ENERGYSILENCE AERO 5200 WHITE/BLACK LINE
41
Publicidad
